MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs

PRICE: $224.95
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
search
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
PRICE: $224.95
MANUFACTURER: JMac Customs
Quantity

Slide backgroundSlide thumbnail
Slide backgroundSlide thumbnail
Slide backgroundSlide thumbnail

10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs

  • MMS - 10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs
  • HG-AKM-10.64-L
  • Easy to measure length
  • 4 Piece Design with 4140 steel threaded upper clamp
  • 5 2/3 M-Lok slots on bottom of hand guard
  • 1913 gas tube extends over gas block
  • Free Float design, clamps on barrel, doesn't interface with receiver
  • Lower and upper mount remain installed and gas tube can be removed/cleaned and replaced without losing zero
  • 1.3" Inside Diameter
  • Cut out for hand guard retainer sling loop
  • 10.64" optimized for 12.5" with GBC-13 exposing only threads, allowing use of any muzzle device or suppressor
  • Compatible with stamped and milled receivers

10.64" AK M-Lok Handguard with Sling Loop Cut - JMac Customs. The M-Lok Handguard from JMAC Customs was painstakingly designed to retain the highest level of accuracy by creating a mounting block that clamps to your barrel near the receiver. There are no additional points of contact from the mounting block to the end of your muzzle. This allows your barrel to move freely causing no negative effects to your barrel harmonics. The lower half of the mounting block is machined from 7075-T6 aluminum alloy, the upper half is machined from a 4041 QPQ steel alloy. Features a 4 piece design with 4140 steel threaded upper clamp, 5 2/3 M-Lok slots on bottom of hand guard and is compatible with both stamped and milled receivers. 

test anywhere message